NSR(Non-Stop Routing不间断路由)保证设备在()发生故障倒换时数据转发和控制面协议都不间断,满足语音、视频、大客户等业务对IP/MPLS网络的高可靠性要求。
A.电源板
B.业务板
C.主控板
D.交换板
A.电源板
B.业务板
C.主控板
D.交换板
A.OSPF
B.RIP
C.EGP
D.BGP
Routing: Beijing, CHINA (BJS) to Boston, U.S.A (BOS)
Commodity: Gold Watch
Gross weight: 32.0kg
Dimensions: 1 Piece 61cm×51cm×42cm
公布运价如下:
A.ip clns routing
B.service-policy isis [name]
C.ip router isis [name]
D.Do not need to configure anything on the interface
A.IPSec(Internet Protocol Security extensions)
B.GRE(Generic Routing Encapsulation)
C.MPLS(Multi-Protocol Label Switching)
D.EON(CLNP over IP)
A.show ip route
B.show ip protocol routing
C.show ip backup route
D.show ip backup routevrf
A.决定路由是否在路由表中为活跃
B.防止路由环To prevent routing loops
C.建议BGPpeer session
D.阻止denial-of-service攻击
①Insert the tail fiber between subracks in the related interface, and bind the extra optical fiber by the yellow adhesive tap, fixing it on the cable immobility board inside the routing area to the right of the rack after routing the fiber through the routing slot in subrack.
②Insert the tail fiber between subracks in the related interface, and fix the extra optical fiber in the fiber-coiling box on the right of the subrack after routing it through the wire-routing slot. When there is very few internal fiber, you can also put the fiber-coiling box on the left of the rack.
③Arrange the optical fiber neatly, and put optical fiber tag on it.
④Decide the wiring path of the optical fiber and put tag on it according to the position of the interfaces on both ends of the optical fiber.
⑤Adopt a sequence of bottom up and from left to right when connecting the optical fiber on the ODU and the OMU board, and the fiber connection order on the OTU board should be the same. When there are multiple OTU subracks on the ODU or the OMU board, first connect the optical fiber between subracks first, and then connect the optical fiber inside the subrack.
A.③-⑤-②-①-④
B.③-⑤-①-②-④
C.④-⑤-②-①-③
D.④-⑤-①-②-③